That’s because the control component was not set constantly because of the power surge they had knocked it offline, and at that point, I didn’t honestly even think that this was something that would ever be an issue
If you have a storm or a power surge or something care about that where your electricity ends up going out, then make sure that you double check your control component unit once the power is up plus running again. Sometimes power surges plus electrical complications can cause your control component to stop laboring constantly, then other times, it can mess up the pre programmed sorry close that you have your heating plus cooling plan seven… This can end up being a giant concern for people who just expect their control component to go on running the way that it did previously! I remember waking up in the middle of the night a single night cold cold plus wondering what was going on with our gas furnace. It turned out that there was nothing wrong with our gas furnace at all, however our control component had not told the gas furnace to turn on. That’s because the control component was not set constantly because of the power surge they had knocked it offline, and at that point, I didn’t honestly even think that this was something that would ever be an issue. It wasn’t something that had ever happened to us before plus so I didn’t realize that having the power go out would mess up the control component settings in the house. I’m ecstatic that I figured it out, though! Now, any time that the two of us have a storm or a power surge, I think that I need to go plus make sure that the control component is laboring constantly! Without a respectfully laboring control unit, your Heating & A/C plan is not going to work the right way.